A good paint job gives the house an attractive interior and turns in into that cozy space that you’ll want to spend your time in. Whether you build your house or acquired it from manufacturers such as American Steel Span, decent painting makes a significant difference.

Is painting a DIY project or you’ll want to call in a professional? Well, with just a bit of experience, you can definitely do the job yourself.

Check out these tips that will adversely enhance the quality of your paint job:


  1. Avoid Overlapping

If you roll over your brush over paint that is already slightly dry, you’ll end up with uneven layers of paint that is unsightly. Remember some types of paint begin to dry within seconds, and you have to be swift.

Make sure that the roller is always wet. If it’s nearly dry, it begins to stick on the previous paint coats. Each stroke of the roller should overlap the edge of the previous one before it begins to dry.

  1. Mix all the Paint at once

If you’re using 4 cans of paint of the same color, you may think of mixing the first two cans then mixing the rest when you’re done with the first half. Paint colors tend to vary slightly from one can to the other. If you mix them separately, the difference may be visible on the wall.

If you’re dealing with a large construction and it’s difficult to estimate the amount of paint required, have more as opposed to less. Any leftover can be preserved.

  1. Start with the Trim

The trim refers to that area between the floor and the wall; mostly a wooden plank. You don’t have to worry about the trim paint touching the wall. It will be covered when painting the wall.

home painting

Your focus here should be attaining a smooth finish, preferably using a small brush. After that part has dried, you can tape it off much easily as opposed to taping the walls. If the ceiling is also involved, paint it first before you embark on the walls.

  1. Cut the tape only after the Paint is Dry

Attempting to pull off the tape before the paint dries will spoil it. The tape will pull off patches of paint. Once it dries, cut the film between the tape and the wall with a knife before pulling off the tape. Eventually, pull off the tape at a 45 degree angle. If you attempt any of these while the paint is still gummy, you’ll spoil the entire trim paint job.

  1. Clean the Walls first

Paint adheres best to clean, dry surfaces. If the surfaces you’re painting on are dirty or oily, the paint will peel or chip off within no time.

There are plenty of detergents in the market specifically designed for pre-paint cleaning. You can use a heavy-duty cleaner or a degreaser to clean the dirty areas. Make sure you protect your hands and eyes when using these chemicals.

The kitchen normally has the dirtiest walls followed by the bathroom. Using a lint-free cloth, start from the bottom to the top cleaning in circular motions. Even where you don’t have significant dirt, wipe with a dry cloth to remove dust.

  1. Repair the surface

If there are nicks, holes and other uneven surfaces on the construction, you have to deal with them before you can think of painting. You can use a filler or a drywall compound.

Do note that even after the filler, it is not advisable to apply the paint directly. Fillers tend to be porous which leads to the absorption of paint. Apply a coat of primer after the filler for a smooth finish.


Leave a Reply

Your email address will not be published. Required fields are marked *